Secure Shakey Rail Without Drilling Into Floor

First the treads or shoe plate on a knee wall or floor level are installed as well as the newel posts.

Secure shakey rail without drilling into floor.

Powder actuated fasteners are ideal for securing 2x4 sleepers to floors furring strips to walls and plywood subfloors to slabs. Typically a package of these screws comes with a masonry drill bit sized to the screw diameter. They provide a strong and fast way to attach to concrete but you. Place the railing in place on the floor place the bracket with one side tight against the rail and one side flat on the floor.

Drill holes into the concrete that are the right diameter for lead shields using a masonry bit in a hammer drill. Level it to the needed height and fill it with concrete. Here you actually screw or rail bolt the rail in place without glue so that it can be removed in a later step. Drill a clearance hole through the wood and into the concrete using a masonry drill.

Place your handrail over this pipe and secure in place with a quick weld or with a screw going through both pipes. This requires drilling a round hole and using a shoe to hide the left over gaps. Insert lead shields into the holes in the concrete. If you can find nails that will penetrate the concrete deeper than 3 4 inch 1 9 cm this can create an even more secure hold.

Set a galvanized anchor bracket in before the concrete sets. I d scrape paint from the base to see what s under there a close look seems to reveal that it may be in pieces that are either screwed together or snapped in the base appears to be cast iron so welding to it may be difficult the holes in the floor appear to be nail holes and not termites in my opinion as a last resort i would cut the base from the floor disconnect it from the wall and get it. Drive a lenght of pipe through the hole and into the ground the concrete will now only secure the pipe against sideway movements while the support is given from the ground. Select nails that will penetrate at least 3 4 inch 1 9 cm into the concrete.

Insert the wood post in the post bracket and screw or nail it in place. Then the handrail is fitted and temporarily attached to the posts or walls. Round hole with base shoe by far the fastest and easiest method. This is usually a much easier job than driving nails by hand.

There are other methods you can use too. To install them position the wood part in place. The following visual guide showcases 6 different methods of installing square balusters with and without shoes. Align and level the brackets and you re all set to secure your shed.

Slide a sonotube in to form it up. Your mortar nails should go through the wood entirely and penetrate the concrete by 3 4 inch 1 9 cm if possible. Use lag bolts or screws to attach the metal post bracket to the concrete.