Section In Rcp Wont Show On Floor Plans Revit

Window door families are not cut based on the cut plane defined in project views.

Section in rcp wont show on floor plans revit.

If the element is part of a design option check the visibility settings of design options in the view. Try changing to wire frame and see what happens. I need to underlay a floor plan on an rcp so my walls show consistently on my electrical lighting plans. If your underlay orientation is set to rcp your cut plane is set below the ceiling height your top is above the ceiling and your discipline is set to architectural all of your above ceiling mep elements will not be visible.

Go to the floor plan view and click in the view range menu in the instance properties. If the project is workshared confirm that the workset of the element is visible in all views. Menglmn just to clarify i d like to get the revit screenshot below to show the walls you see in the cad screenshot. Anyway over time i ve seen and heard plenty of suggestions on what a user should or should not do to expose missing elements but the following top 10 reasons is the most comprehensive check list i ve seen.

The door plan swing and panel symbolic lines exist at the floor level so if anything is above the floor level where the door is those lines well get obscured. If the view range of your rcp is such. Section marker not showing up in all plans. See change the clip plane in an elevation view and about section view width and depth.

I guess it s the autocad mentality that is so hard to shake at first. And a screenshot of the properties of one of the walls that wont show up. Everything cut by the pink line like in the image below will display in thick lines. Setting section view to coordination discipline will allow the section line to show in both views.

I drew a section in the first floor plan. See check the design option settings for a view. If the door appears then there s something obscuring it. But section is architectural it won t show in the roof plan.

In a floor plan view the key parameters are cut plane and bottom. First verify that. Set a level and a height offset for each of these parameter. Instead they are cut based on the cut plane defined in the family s plan view.

When i go to the roof plan the section marker isnt showing up.